Home / E-Store / Amplifiers / Cellular Antennas / Fixed Wireless Terminals / Docking Stations / Cellular Desk Phones / Downloads
In cooperation with Numerex Corporation, OmniCell Communications and UpLink want to help you receive
the best possible cellular signal from your DigiCell(R) AnyNET Network Access Module.
End Users...
If you are looking for a wireless solution for your security and/or monitoring system, please
contact the folks at Uplink...1.888.9Uplink (888.987.5465).
Security/Monitoring Installation...
If you are currently working with Uplink and installing their cellular modules, we can help you
with your signal enhancement.
Below are the antennas and antenna systems that Uplink support may have mentioned as a solution
to your signal problem. The lower the outdoor signal, the greater the difficulty in bringing that cell signal indoors
to the module.
| Mag-Mount Antenna #301125 |
|
Magnetic Mount Antenna #301125...
This mag-mount antenna is an omni-directional antenna with a rare-earth magnet in its base. The antenna
is 12.25" and does require a ground plane of approximately 8" x 8" minimum.
It comes with its own 10 foot cable (RG 174) and terminates with a SMA male connector. The antenna
provides approximately 10 - 15 dB system gain and will, in many cases, increase your indoor signal strength to a very
good level. This antenna is not recommended for outdoor use.
Price...$39.95 (Antenna Only)
| Trucker Antenna #301101 |
|
Trucker Antenna #301101...
The 'trucker' antenna is a rugged, omni-directional antenna that will weather any storm. With its
threaded base, a 3-way mount is needed to attach the antenna to a mast, fascia, or other structure. This antenna, too,
comes with an attached 12' cable (RG 58) and terminates with an FME female connector.
If 12 feet is long enough for your installation, you can connect this antenna directly to the Uplink module
by using the FME male/SMA male connector adapter.
Price $81.00 (All Components)
|
| 3-Way Roof Mount |
Common Connector Types
The connector on the Uplink module is a SMA Female connector. The 'Trucker' antenna
cable terminates with a FME Female connector. The #301125 Mag-Mount antenna cable terminates with a
SMA Male connector. Most pre-made coaxial cables (if an extension is necessary) come with N
Male connectors on each end.
| SMA Male/N Female Connector Adapter |
|
|
| SMA Male/FME Male Connector Adapter |
